Hardware Questions

LCD not working
In one known case, the 4 wires in the connector were erroneously placed, so a Trinus Creatives group member posted his proven solution of swapping the conne...
Tue, 3 Jan, 2017 at 3:24 AM
What SD card can I use on my Trinus?
The printer has no problem reading SD SDHC cards with capacity of up to 32Gb. SDXC cards with higher capacity are problematic. Please transfer your files to...
Tue, 3 Jan, 2017 at 3:25 AM
What Do All the Lights and Beeps Mean?
Mainboard (PCB): Single Color LED: (Relates to basic controller state) 1. BLUE: SD Card IN 2. RED: Nozzle heater ON 3. Green: Power 5V on 4. Yellow: Power...
Sat, 21 Jan, 2017 at 11:06 PM
Extruder Makes a Clicking Sound and Doesn't Feed Filament
This sound indicates the extruder is trying to push filament but the heat block (hotend) is not yet hot enough to melt plastic OR the extrusion (pushing of ...
Sat, 21 Jan, 2017 at 11:07 PM
Avoid Damaging Your Heated Bed Cable
That shouldn't really happen, the cable should have a much longer service life.  But we have had at least 4 instances where the heated bed power co...
Sat, 21 Jan, 2017 at 11:11 PM
Guide to Bed Leveling - without the leveling system
Okay... first of all, this is probably the first difficult challenge to anybody running a 3d printer for the first time. That's the bad news. The go...
Wed, 4 Oct, 2017 at 4:25 AM
Printing Stops Mid-Print
Stopping at random locations can be caused by one or more things: 1) split second, temporary disconnection of thermistor circuit -- usually at the plug/...
Wed, 4 Oct, 2017 at 4:21 AM
How to adjust the bed leveling system...
1) Start by tightening all the four corner screws so that the springs are completely compressed. 2) Adjust the Z endstop screw such that the nozzle is abo...
Sat, 21 Oct, 2017 at 7:42 AM